uSDM102 Lap Timing using an infrared Beacon connected to DI4.
(min FW version 0.0.26, min Plex Device Manager version 0.66.0)
-
-
The Infrared Beacon Receiver output must be connected to Input4 of the uSDM102.
-
Input4 does not have to be enabled/configured as a DI input, but it must NOT be enabled as an Analog Input.
-
In the Diagnosis screen a flag named "BEACON" will be visible and will indicate the current state of the input.
Configuration setup:
Set the Lap Timing Source to: BEACON on DI4
Set the Beacon Ignore time to a minimum of 5s.
Lap Timing Pop up Page:
A page showing the just completed lap time and the best lap time will be shown for 'New Lap Display s'.
-
The internal channel LAP must be enabled and the LAP COUNT function assigned to it.
-
The internal channel LAP t must be enabled and the LAP TIME function assigned to it.
-
The internal channel prevLAP t must be enabled.
-
The internal channel bLAP t must be enabled.
Logging and analysis set up:
Make sure that the following internal channels are enabled to get useful information in the log files and comparisons between laps can be performed:
LAP, LAP t, prevLAP t. Also essential is a ground speed channel. A vehicle/drive speed channel can be used as long as the wheels do not spin.
