How to configure individual channels

1. In Scal / Datastreams / Custom Can / Frame Content add the desired channel.
It there is a SPARE position available then use that so that existing datastream is not changed. If not then replace a channel that is not needed.
 
ex. Add FuelComp channel in the 4th slot of frame 2.
 
Take note of the conversion equation displayed near the top of the page when the channel is highlighted.
 
2. Go to Scal / Datastreams / Custom Can / Frame Identifier and note the ID of the frame containing the channel
In this case the ID of frame 2 is 0x601.
 
3. In the Plex Device Manager / Device Configuration / CANx Receive Setup add a new channel or if replacing an existing channel double click to edit.
Set the parameters according to the channel position in the datastream and conversion format.