×
Menu

Motec LTC

 
WIRING
The SDM-500 can receive lambda values from up to 8 Motec LTC lambda controllers over CAN2.
 
The CAN2 pins 6 and 7 of the SDM-500 should be connected to the Motec LTC CAN BUS.
If more than one LTC is used then LTC1 should be configured as a Master with transmit address 0x460 and the rest as slaves.
Read the Motec LTC User Manual for details on configuration.
 
The received lambda values will be displayed as LAMBDA1 through LAMBDA8.
For LTC1 additional diagnostic information is available via the "LA 1 Cold", "LA1 HEAT ER" and "ER LA1 ER" status and error flags.
 
PLEX uSDM-SDM-VMU CONFIGURATION