×
Menu
5.3. PAGES
 
uSDM100, uSDM102,SDM300, SDM500
Automatic Page Switching function:
The uSDM100/102,SDM300/500 can be set up to automatically switch up to 4 display pages depending on conditions.
To enable the automatic pages the relevant page setting has to be set to the desired page number as seen in front of the page name in the Pages tab.
·     Warm-up page: This page will be displayed when the data channel that is set to the "Water Temp" function is bellow the Min water Temp value.
·     Normal page: This page will be displayed when the data channel that is set to the "Water Temp" function is above the Min water Temp value.
·     Race page: This page will be displayed when the data channel that is set to the "Tps" function is above the Min Tps value or when the the data channel that is set to the "Map" function is above the Min Map value and at the same the data channel that is set to the "Rpm" function is above the Min Rpm value.
·     Error Page: This page will be displayed when any of the data channels that are set to the "Sensor Faultxx" function are different from 0.
 
When the conditions that caused the automatic page change become false the device will display the previous page after the delay set in Pages Autoswitch Delay ms has passed.
 
uSDM100, uSDM102
Controlling how the pages are switched:
There are 2 ways to control pages switching on the uSDM100/102
·     With the bottom button on the device. A single press advances to the next page. A long press goes back to the first/home page.
·     With a data channel value by setting its function to Page Control. Whenever the channel value changes the corresponding page number will be displayed. If the value is invalid the last displayed page will be show.
 
Limiting the pages available to the driver:
This setting allows for liming the pages that the driver can see and scroll through while the vehicle is in motion.When the data channel set to the "Drive Speed" or "Ground Speed" function is above 5kph only pages with numbers bellow the Pit Pages Start value can be displayed.
If the setting value is 0 then then all pages are available while driving.
 
The Splash Screen Display setting determines how long the splash screen will be displayed.
The Night Brightness Threshold setting determines the light level bellow which the screen brightness will be reduced to improve night driving.
Min water Temp, Min Tps, Min Map,Min Rpm are adjustable in the Functions Setup.
 
SDM300, SDM500
Controlling how the pages are switched:
There are 4 ways to control pages switching on the SDM300/500
·     With the side navigation switch on the device.
·     With the Plex Joystick Controller by setting the Page Control Source to Joystick.
·     With external buttons by setting the Page Control Source to Buttons.
·     With a data channel value by setting its function to PAGE CONTROL. Whenever the channel value changes the corresponding page number will be displayed. If the value is invalid the last displayed page will be show.
 
 
The Splash Screen Display setting determines how long the splash screen will be displayed.
The Color Theme setting determines the color pallet used to build the display pages.
The Light for min Brightness setting determines the light level bellow which the screen brightness will be set to minimum.
The Light for max Brightness setting determines the light level above which the screen brightness will be set to maximum.
Between these 2 light levels the screen brightness will be calculated in a linear fashion.
 
Min water Temp = the LOW setting of the data channel that is assigned the WATER TEMP function.
Min TPS = the HIGH setting of the data channel that is assigned the TPS function.
Min Map = the HIGH setting of the data channel that is assigned the MAP function.
Min Rpm = the HIGH setting of the data channel that is assigned the RPM function.
 
SDM700