Receiving commands from the SDM - S6GP
To be able to control the Syvecs calibration switch position you need to adjust the following settings:
-
to YES.
-
to 2000.
-
IO Configuration\ Pin Assignments\ Cal Down to NOT CONNECTED
-
IO Configuration\ Pin Assignments\ Cal Up to NOT CONNECTED
-
IO Configuration\ Pin Assignments\ Calibration Switch to NOT CONNECTED
-
Make sure that the calSelect channel is received by the SDM and assign the ECU CALIBRATION function to it.
-
Add the "Ecu Control" page in your Pages configuration.
-
Click on the page preview to display the settings and on the first setting select Ecu Type:S6GP/S6+.
-
Ignore the rest of the settings.
-
Write the device configuration.
-
When viewing the Ecu Control page on the dashboard, use the ENTER button to select the knob and the UP/DOWN buttons or joystic to change the value.
-
Use the ENTER or BACK buttons to deselect the knob and allow navigation to other pages.